向心關節軸承的公差

                                  欄目:向心關節軸承 發布時間:2019-10-11

                                  向心關節軸承公差
                                  Tolerances for radial spherical plain bearings 
                                  1>.向心關節軸承公差(除 PB, GEBJ…S外) Tolerances for radial spherical plain bearings(except for series PB...,GEBJ...S)

                                  1-1.png

                                  帶 * 號為 GE…LO 的公差 The deviations in the columns with symbol*apply to spherical plain bearings of series GE…LO.
                                  外圈 Outer ring
                                  1-2.png
                                  2>.PB...公差 Tolerances for series PB…
                                  內圈 Inner ring
                                  1-3.png
                                  外圈 Outer ring
                                  1-4.png
                                  3>. GEBJ...S 公差 Tolerances for series GEBJ...S,
                                  內圈 Inner ring
                                  1-5.png
                                  外圈 Outer ring
                                  1-6.png
                                  尺寸和公差符號 The symbols of dimension and tolerance
                                  d: 軸承公稱內徑。 Bearing bore diameter, nominal.
                                  △dmp: 單一平面平均內徑偏差。 Single plane mean bore diameter deviation.
                                  Vdp: 單一徑向平面內徑變動量。 Bore diameter variation in a single radial plane.
                                  Vdmp: 平均內徑變動量: mean bore diameter variation.
                                  △Bs: 內圈單一寬度偏差 .Deviation of a single width of the inner ring.
                                  B: 內圈公稱寬度。 Width of inner ring, nominal.
                                  D: 軸承公稱外徑。 Bearing outside diameter, nominal.
                                  △Dmp: 單一平面平均外徑偏差。 Single plane mean outside diameter deviation.
                                  VDp: 單一徑向平面外徑變動量。 Outside diameter variation in a single radial plane.
                                  VDmp: 平均外徑變動量。 Mean outside diameter variation.
                                  △Cs: 外圈單一寬度偏差。 Deviation of a single width of the outer ring.
                                  C: 外圈公稱寬度。 Width of ourer ring, nominal.
                                  △Ts: 角接觸關節軸承實際寬度偏差。 Actual deviation of width of the angular contact spherical plain bearing.
                                  △Hs: 推力關節軸承實際高度偏差。 Actual deviation of height of the spherical plain thrust bearing.
                                  hs,△h1s: 桿端關節軸承或球頭桿端關節軸承中心高偏差。 Center height deviation of rodends or ball joint rod ends.

                                  上一篇: 沒有了
                                  日韩高清成人免费播放视频在线观看